
Motion Pro 2-Stroke Timing Kit
Includes dial indicator with extensions and a
14mm spark plug thread adapter. Allows inspection and adjustment
of ignition timing. Gauge face size is 1 1/2". For water
cooled engines.
$124.95 (3801-0030)
Adapter
kit for air cooled engines
Includes an extended thread adapter and dial
indicator extension. Allows Water Cooled Kit to be used on air
cooled engines. $11.95 (3801-0029) |

CABLE
LUBER
- Used to inject lubricant into cable
housing
- Clamps over housing and wire allowing an
aerosol can to be connected
- Once lube runs out the far end, the
cable is lubricated
- $9.95 (08-0182)
|
Soft
Tie Extensions
If you’ve got to tie your bike
down, this is the best protection for expensive paint and chrome. Loop
this one-inch nylon webbing around your handlebars, fork braces, or rear
seat rails and insert a tie down hook—metal-to-metal contact is
completely eliminated. Rated at 1200 lbs breaking strength with a 400
lb. working load capacity per strap. Pair of two. 12-inch length.
$5.95
(17-0254)
|
Terminal Crimper Tool

For B-series Terminals
$26.95 (CR1)
|
|
Spring Installation tool

-
T-handle spring puller
provides a secure, comfortable grip for maximum leverage
-
Allows mechanics to remove
exhaust springs in seconds
$6.95
(FMF011231)
|
2-STROKE LEAK-DOWN TESTER

- Designed to check for air leaks in
2-stroke engines
- Includes air pressure gauge, pump-up
bulb and most fittings and adapters for single- and twin-cylinder
2-stroke motorcycle engines
- Packed in a convenient carry box,
complete with instructions
- Made in the U.S.A.
- This is the tool we use at HVCcycle.
$308.95 (P538) |
|
Yamaha RD Axle Wrench

-
This is a copy of the axle
wrench that was supplied in the original tool kit. 22mm & 29mm
-
Makes loosening and
tightening the double nut on the axle easy without interfering with
the exhaust.
-
Made from hardened tool
steel and zinc plated.
-
Works on the following
-
Yamaha R5 and DS7
-
Yamaha RD250 and 350
-
Yamaha RD400, 1976-1978
$17.99
(HVC200124)
|
Mikuni
Service Tool Kit
Handy kit includes all tools necessary to completely
disassemble Mikuni carbs, change jets, etc.

$11.95
(12-1866) |
|
FLEX HONE

Available in many sizes other than listed.
Listed are the sizes that work the best on the Yamaha
2-stroke twins
|
|
Fly Wheel Rotor
Puller |
 |
|
|
|
$4.50 (HVC200136)
|
|
|
Ignition Timing Tester
(buzzbox)

Eliminates the guesswork when timing a
points-type ignition. Allows you to concentrate on adjusting the points
without having to look at your multi-meter for a reading, just listen for
the audible tone to know when your points close. A switch allows for either
a light or a tone at the moment of point closure Can also be used as a
continuity tester.
$39.00 (LM4100)
|
|